|
|
Build Your Online Product Catalogs?
| Product Name: |
JGD-2 Rubber Bellows Joint,flage mountedrubber
|
| Supply Ability: |
|
| Related proudcts |
|
| Specifications |
standard |
| Price Term: |
|
| Port of loading: |
|
| Minimum Order |
|
| Unit Price: |
|
|
rubber expansion joints for pipe are designed for piping systems to absorb pipe movements, relieve stress, reduce system noise/vibration, compensate for misalignment/offset and to protect rotating mechanical equipment against start-up surge forces.
rubber expansion joints manufacturer has been successfully installed in tough demanding applications such as: Chemical/Petrochemical, Marine, Power Generation, Pulp/Paper, Steel Mills and Water/Wastewater Treatment.
Features and Benefits:
1, Versatile hand-built construction. Made in China
2, Rubber Bellows to Absorbs directional movement
3, Absorbs vibration, noise and shock
4, Rubber Bellows Compensates for misalignment
5, Wide flowing arch design
6, Virtually eliminates sediment buildup
7,Higher pressure rating than conventional expansion joints
8, High vacuum rating (up to 30" Hg) can be supplied for certain sizes
9, Economical fully molded construction
10, Solid galvanized steel floating flanges speed the installation time
11, High tensile aircraft cable is embedded in the raised face rubber ends to prevent pull out and avoids the sharp cutting edge of solid steel rings
12, No gaskets required; integrally rubber flanged design, no gaskets required, DIN PN10/16 drilling standard, other flange drilling available, including ANSI 150lb/300 lb, BS, and JIS
Applicable Media air, compressed air, water, sea water heated water, oil, acid, alkali
Note:
1. Supply range can be up to DN3000, ***ailed data can be offered upon request.
2. Control units must be used when piping is not properly anchored.
3. The rated pressure 2.5*** products will only be sold with control units.
4. Pressure rating is based on 30degrees centigrade operating temperature. The pressure rating is reduced at higher temperatures.
5. Weights in the above table are joints with DIN PN16 drilling retaining ring flanges.
6. Movements shown in the above table are non-concurrent.
7. Rated pressure in the above table is the maximum "working pressure". Test pressure is 1.5 times "working pr |
| Company: |
Gongyi Liangda Tubes Co., Ltd
|
| Contact: |
Ms. amy wu |
| Address: |
8th Fumin Rd, Zhongyuan District |
| Postcode: |
450000 |
| Tel: |
86-371-60388868 |
| Fax: |
86-371-67636798 |
| E-mail: |
|
|
|
|
Home
